Alberta School Bus Driver Test 02

It is important to arrive at the exam center on time, ask for clarifications if necessary, and read each question carefully. Remember to take breaks and stay calm throughout the test. Passing your official exam with flying colors requires much effort, but it is well worth it. As a successful school bus driver, you will ensure the safety of children and provide reliable transportation to and from school. With your hard work and dedication, you will be an asset to your community and make a positive impact on children’s lives.

Alberta School Bus Test 02

1 / 30

The majority of reported injuries due to collisions are what type of injuries?

Whiplash

Cuts and bruises

Broken arms

Sprained ankles

2 / 30

What does holding the vehicle in too low a gear while the engine races cause?

Excessive wear on an engine

Sluggish acceleration

Nothing

Poor mileage

3 / 30

Your alternately flashing lights are to always be used for loading or unloading, unless...

They are not working

None of the above

There is no traffic following or approaching the bus

There is a municipal by-law prohibiting their use in a given jurisdiction

4 / 30

What is the top reason to keep your school bus clean inside and out?

Smells better

Keeps the resale value up

It's a good habit to have

Safety

5 / 30

If you require additional power to accelerate quickly in an automatic transmission vehicle, what would you need to do?

Depress the accelerator firmly to the floor, which will cause the automatic transmission to downshift giving you more power to accelerate

None of the above

You can't do anything as the transmission changes automatically

Place the gear selector in a much lower gear

6 / 30

How long does a carrier need to retain the record for a school bus?

At least three years from when they were created, established or received

At least five years from when they were created, established or received

At least two years from when they were created, established or received

At least one year from when they were created, established or received

7 / 30

If you do a thorough job in the afternoon with the post-trip inspection, how does this help you?

Your employer is pleased

None of the above

It makes your pre-trip inspection easier

You have time for a nap

8 / 30

What is the National Safety Code (NSC)?

The code of conduct for all commercial vehicles

None of the above

Safety regulations for the province of Alberta

An agreement between federal and provincial governments to have minimum performance standards

9 / 30

Signally right will indicate your intentions to change lane position. When should you do this?

At approximately 125 metres

At approximately 50 metres

At approximately 100 metres

At approximately 75 metres

10 / 30

How far should any ignition be of the dispenser or container being filled of propane?

It doesn't matter

5 metres

7 metres

3 metres

11 / 30

As a professional school bus operator, what is your main objective?

To serve your community

To safely transport passengers to their destinations

To ensure the vehicle runs smoothly

To report any mechanical problems to your employer

12 / 30

What is referred to as the service brake?

The parking brake

The time when the brakes are being serviced

The foot brake used by the driver while the bus is in operation

The air brake

13 / 30

The magnetic float gauge attached to the tank should indicate the tank is now filled to capacity to a total capacity of the tank of how much?

90%

95%

100%

80%

14 / 30

Once an operator is back at the yard or their park-out location, what should the driver do?

Leave

Lock all the windows

Turn off the ignition

Walk through the bus one last time

15 / 30

What does GVW refer to?

Grand Variable Wish

None of the above

Gross Vehicle Weight

Grand Vehicle Weight

16 / 30

If the bus takes propane, who is allowed to refuel the bus?

The owner of the bus

The maintenance team

Only personnel with proper certification or training

The driver of the bus

17 / 30

If there is a stop coming up and if there is traffic following or oncoming, what should the driver try to do?

Stop as normal but put the yellow lights on early

Do as you normally would do

Let it pass, do so by slowing down well before the stop and allow the traffic to clear

Ignore the yellow lights and just put on the flashing red lights

18 / 30

How often do CVIP Inspection occur?

When needed

Annually

Every quarter

Semi annually

19 / 30

For propane fueled buses, when liquid level reaches maximum permitted in the tank, what happens next?

Liquid propane in the form of a mist will be discharged from the liquid level gauge, which means fuelling should now be terminated

There is a malfunction with refueling

The valve shuts off automatically

The tank is full and nothing happens

20 / 30

Does the maintenance and inspection program be in writing?

Only during post-trip inspections

Only during pre-trip inspections

Yes

21 / 30

What does shifting before the proper engine speed is reached cause?

A loud noise from the engine

Grinding of the gears

The engine to lug which can be hard on the engine

It makes shifting gears tougher

22 / 30

For units equipped with the 'No Child Left Behind' or Child Check-mate System', what is not part of the check?

Deactivate the Child Check-mate System if it is equipped on that unit

Checking if any passengers are left in the vehicle

Calling the parents if things are left behind

Walk through the bus one more time, checking for articles left behind and passengers

23 / 30

The driver shall not move the school bus after the disembarking until the student is observed doing what?

To have reached a place that is safe from the traffic

Has given the driver a thumbs-up symbol

Looking back at the driver

Has been picked up by a family member

24 / 30

When should the driver activate the alternately flashing amber lamps?

It's their complete judgement

When that person stops on a highway to load or unload passengers

When that person begins to slow down the school bus for the purpose of stopping on a highway to load or unload passengers

Before that person begins to slow down the school bus for the purpose of stopping on a highway to load or unload passengers

25 / 30

Where do the majority of school bus-related fatalities (62%) occur?

On the steps of the bus

Anywhere

At the rear of the bus

Outside the school bus

26 / 30

When would you drive in a lower gear with an automatic transmission?

During curves

Due to difficult terrain to give better traction and assist in reducing tire spin

You wouldn't

On wet roads

27 / 30

What is referred to as 'double clutching' ?

None of the above

Where you have two clutches

A procedure where you depress the clutch pedal, release it and depress it again while shifting gears

Where you must depress the clutch twice because the transmission did not change gears correctly

28 / 30

What does MRC refer to?

Manufacturers Rated Capacity

Maintain Running Charter

None of the above

Master Reliability Check

29 / 30

When should the alternatively flashing yellow lights be activated?

As you first begin to slow for the purpose of loading or unloading passengers

Just before stopping and putting on the flashing red lights

As you feel

After slowing down

30 / 30

What is the definition of 'roadway' in the TRAFFIC SAFETY ACT?

Any part of a path used for traffic including pedestrians

That part of a highway intended for use by vehicular traffic

None of the above

Private laneways

Your score is

By WordPress Quiz plugin

Alberta School Bus Driver Test 02

About

Practice Tests

Getting a License

Get In Touch