Ontario Bus Driver Test 08

It would be best to dedicate enough time to study and prepare for the test. Luckily, there are various resources and study materials available that cater to the specific requirements of the Ontario bus driver practice test. So, whether you’re an experienced driver or new to the industry, use these tools to increase your chances of success.

Ontario Bus Test 08

1 / 30

Which statement is false? While inspecting the windshield, what would you be looking for?

It has streaks

It is clear

It has no damage to the glass

It has no obstructions

2 / 30

What could happen if you license plate is not visible?

Your driver's license is suspended

None of the above

The vehicle can be taken out of service

You could be fined

3 / 30

What happens if the student safety crossing arm is missing?

Report it as a minor defect

All of the above

Let your employer know

Tell your passengers to be careful

4 / 30

When going through an intersection, when should any necessary transmission shifts be made?

During the first half of the intersection

During the last half of the intersection

None of the above

Prior to entering an intersection

5 / 30

Why should you check the mirrors after clearing an intersection?

It allows you to be continually aware of conditions so that necessary adjustments in speed and position can be made

To ensure the mirrors are still operational

All of the above

To look for a space to change lane in the intersection

6 / 30

When performing a lane change, you should operate within how much of the posted speed limit if conditions permit?

5 km/h over the limit

10 km/h over the limit

10 km/h

15 km/h

7 / 30

Which of the following is not a defect regarding the seat back or passenger-protection barrier padding?

Too much

Partially missing

Missing

Shifted from position so as not to be effective

8 / 30

At what speed should backing always be done?

Barely moving

20 km/h

Walking speed

None of the above

9 / 30

Is it required to inspect the steps and floor?

Yes

If your employer asks you to

Only if the bus is older

10 / 30

Which statement is false? The following are locations that are not suitable for making a lane change, including...

Solid pavement markings

Pedestrian crossings

Railway crossings

Areas with a broken white line

11 / 30

When the seat is damaged or won't stay in the position needed to drive, what problem does this pose?

A major defect

None of the above

The vehicle is placed out of service

A minor defect

12 / 30

What's the purpose of stopping with enough space between your vehicle and the vehicle ahead?

It's the law

So as not to hit that vehicle

It allows you to be able to manoeuvre the vehicle if necessary

All of the above

13 / 30

What kind of defect is it when the stanchion padding is damaged?

Major

Just clean it up

Minor

It's not

14 / 30

The glass surface of any mirror is a defect if it does not have a non-reflective area of more than...

5 square cm

6.5 square cm

7.5 square cm

4.5 square cm

15 / 30

While stopped, where should you continue to look?

All of the above

The interior mirrors to watch the passengers

Traffic ahead, beside and in the vehicle mirrors

The dashboard

16 / 30

What kind of a defect is it when the passenger seat is occupied and the seat is insecure?

It's not a defect

Just ask the passenger to move

Major

Minor

17 / 30

Practise progressive gear shifting at approximately how many rpm?

900 rpm

2100 rpm

1200 rpm

1600 rpm

18 / 30

Which of the following is not a defect when the Emergency equipment is...

Doesn't work properly

Missing

Damaged

The wrong size

19 / 30

Which of the following is not a minor defect with regards to the stop arm for a Class B and E vehicle?

Stop arm or stop sign is damaged so as to significantly affect visibility

Stop arm will only extend fully

Stop arm or stop sign is missing

Either light on stop arm is inoperative

20 / 30

How long should you typically let your vehicle warm up?

3 to 5 minutes

60 seconds

10 minutes

30 seconds

21 / 30

For a manual transmission vehicle why should you run the engine in the highest gear range?

To give it more power

To save on brakes

To help keep it in low revs

All of the above

22 / 30

While exiting the expressway, where should you slow down?

One km before the exit lane

Prior to entering the exit lane

The exit lane

Half way down the exit lane

23 / 30

Which of the following is not a defect if the wiper blade is...

Damaged

Missing

Wrong size

Fails to adequately clear driver's field of vision

24 / 30

Which of the following is not an advantage of having a proper warm-up?

It reduces leakage

It reduces wear

It warms up the brake lines

It helps lubricate components and seals

25 / 30

How long should you let your vehicle warm up if the temperature is below 0 degrees Celsius?

7 to 10 minutes

3 to 5 minutes

30 seconds

60 seconds

26 / 30

When passengers have entered the bus, what should you see before moving the vehicle once again?

That all belongings are on the floor beside the aisle

All of the above

That all passengers have seated safely

That the students are all quiet to avoid distracting you

27 / 30

What's the problem with taking too much time to perform a lane change?

You may forget what you were doing

It allows the traffic patterns to change during the lane change

It slows down the vehicle

All of the above

28 / 30

Are first aid kits required to always be complete?

Only on larger buses

Yes

Not if the driver is properly trained in first aid

29 / 30

Which statement is false? You should you turn off your engine when you stop for any length of time, other than when loading or unloading passengers...

Save fuel

Prevents unnecessary emissions

Reduce maintenance requirements

Keeps the bus hidden

30 / 30

Why should you back off the accelerator when going down a hill?

It helps to slow down

To let gravity and momentum do the work

Saves brakes

All of the above

Your score is

Ontario Bus Driver Test 08

About

Practice Tests

Getting a License

Get In Touch